2 - SAFETY PRECAUTIONS
2 - SAFETY PRECAUTIONS
PLEASE READ - SAVE THESE INSTRUCTIONS
When using an electrical power tool, basic precautions should always be followed to assure maximum safety and optimum performance. Read this manual before assem- bling and operating this power tool. Failure to comply with instructions may result in electrical shock, burns, fire, or personal injury.
WARNING
1.FOLLOW ALL SAFETY INSTRUCTIONS listed in this manual before/during operation of this trimmer.
2.TO REDUCE THE RISK OF ELECTRIC SHOCK this power tool has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a quali- fied electrician to install the proper outlet. Do not change the plug in any way.
3.INSPECT UNIT FOR DAMAGE to the housing, cord or plug. Keep all fasteners tight. Do not use if the switch does not turn the unit off properly. Never use unit if cord or plug has been damaged, the motor or unit itself is not working as it should or has been dropped, damaged, left outdoors or dropped in water. Never operate with any air opening blocked. Keep air openings free of debris that may reduce air flow. Replace damaged parts that are chipped, cracked or damaged in any way.
4.
DOUBLE INSULATED to help protect against
electric shock. Double insulation construction
consists of 2 separate “layers” of electric insulation. power tool built with this insulation system are not intended to be grounded. As a result, the extension cord used with your unit can be plugged into any con- ventional 120 volt electrical outlet. Normal safety pre- cautions must be observed when operating an electri- cal power tool. The double insulation system is only for added protection against injury resulting from a possi- ble internal electrical insulation failure.
5.GROUND FAULT CIRCUIT INTERRUPTER (GFCI) receptacle may be used on an outlet or circuit for an added measure of safety.
6.EXTENSION CORD - Use only with an extension cord intended for outdoor use. Match wire gauge to the cord length. See table below. A
4
MINIMUM WIRE GAUGE RECOMMENDATIONS
VOLTS | EXTENSION CORD | WIRE SIZE | |
LENGTH | REQUIRED | ||
| |||
| 25 feet / 7.5m | 18 A.W.G.* | |
120 | 50 feet / 15m | 16 A.W.G.* | |
| 100 feet / 30m | 16 A.W.G.* |
*American Wire Gauge
Table 1
a.When using the power tool, an extension cord of ade- quate size must be used for safety and to prevent loss of power and overheating.
b.The extension cord must be specifically intended for outdoor use and marked “SJ” or “SJT” and with the suffix “WA”. In Canada, the extension cord must be marked “SFTW”.
c.Inspect extension power cord for loose or exposed wires and damaged insulation. If damaged, replace before using power tool.
DO NOT ABUSE CORD - Never carry power tool by cord or pull cord to disconnect from outlet. Keep cord clear of operator and obstacles at all times. Do not expose cord to heated surfaces, oil or water. Do not pull cord around sharp edges, corners or close door on cord.
7.NO SERVICEABLE PARTS INSIDE - Your dou- ble insulated power tool has no serviceable parts
inside. Do not attempt to repair it yourself. For service information, contact the McCulloch Product Service Department listed on the back cover of this User Manual.
8.Avoid dangerous environment. Do not use power tool in damp or wet locations.
9.Don’t use in rain. Water entering a power tool will increase the risk of electric shock.
10.Do not abuse cord. Never yank it to disconnect from receptacle. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase the risk of elec- tric shock.
PERSONAL SAFETY
11.Keep children away. All visitors should be kept at a distance from work area.
12.Dress properly. Do not wear loose clothing or jewel- ry. They can be caught in moving parts. Use of rubber gloves and substantial footwear is recommended when working outdoors. Wear protective hair covering to contain long hair.
13.Use safety glasses. Always use face or dust mask if operation is dusty.
14.Stay alert, watch what you are doing and use com- mon sense when operating a power tool. Do not use tools while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury.
15.Avoid unintentional starting. Do not move plugged- in appliance with finger on switch. Be sure switch is off when plugging in.
16.Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in unexpected conditions.
17.No accessories or attachments are necessary for the operation of this gardening tool. The use of any accessories or attachments for this gardening tool is not recommended. Such use of any attachment or accessory may increase the risk of injury to the user.
18.Do not use force. The correct tools will do the job better and safer at the rate for which it is designed.
19.Disconnect the plug from the power source before making any adjustment, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally.
20.Store tool inside when not in use. Tools should be stored indoors in dry, and high or
21.Maintain tools. Keep cutting tools sharp and clean for best performance and to reduce the risk of injury. Follow instructions for lubricating and changing accessories. Inspect tool cord periodically, and if dam- aged, have it repaired by an authorized service facili- ty. Keep handling surface dry, clean, and free from oil and grease.
22.Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be care- fully checked to determine that it will operate properly and perform its intended function. check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is dam- aged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in this manual.
2-2. HEDGE TRIMMER SAFETY RULES
1.The Hedge Trimmer must not be used by anyone under the age of 16.
2.Keep children, other people and pets away from the trimmer.
3.Always dress properly. Don’t wear loose clothing or jewelry; they can be caught in moving parts. Use of rubber gloves and substantial footwear is recom- mended when working outdoors. Wear protective hair covering to contain long hair.
5
4.Use face or dust mask when used in dusty conditions.
5.Do not use the trimmer if the cutting blade is not secured properly or is damaged.
6.Before starting the trimmer, make sure that the cutting blade is not touching stones or debris.
7.When the trimmer is in operation, keep the cutting blade away from all parts of the body.
8.Do not cut hard objects. This could cause injury or damage the trimmer.
9.Only cut during broad daylight or with corresponding artificial light.
10.Don’t abuse cord, never carry hedge trimmer by cord or pull with force to disconnect from receptacle. Keep cord from heat, oil, and sharp edges.
11.When the trimmer is not in use, store it in a dry place and out of the reach of children.
12.The outlet voltage must correspond to the one marked on the technical data plate. Do not use other sources of power.
13.Never use the trimmer when it is raining. Try to prevent it from getting wet or being exposed to humidity. Do not leave it outside overnight. Do not cut damp or wet bushes.
14.The power supply cord should be checked regularly. Before each use, make sure cord is not damaged or worn. If the cord is not in good condition, do not use the trimmer. Take it to an authorized service center for proper repair.
15.Only use an extension cord which is suitable for out- door work. Keep it away from the cutting area, damp, wet or oily surfaces, or sharp edges. Keep away from heat and fuels.
16.Avoid unintentional starting. When transporting the hedge trimmer with the power supply connected between tasks either turn switch to “OFF” or avoid touching both switches at the same time.
17.Do not attempt to remove cut material or hold materi- al to be cut when blades are moving. Make sure trim- mer switch is off when clearing jammed material from blades. Do not grasp the exposed cutting blades or cutting edges when picking up or holding the hedge trimmer.
18.Don’t force hedge trimmer, it will do the job better and with less likelihood of risk of injury at the rate for which it was designed.
19.Stay alert, watch what you are doing. Use common sense. Do not operate hedge trimmer when you are tired.
20.Maintain hedge trimmer, keep cutting blades sharp and clean for best performance and to reduce the risk of injury. Inspect extension cord periodically and replace if damaged. Keep handles dry, clean and free from oil and grease.
