SAFETY PRECAUTIONS
Explanation of Symbols on your Product (Check which symbols apply)
1.Warning.
2.Read the user instructions carefully to make sure you understand all the controls and what they do.
3.Switch off! Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged. Keep the cable away from the cutting parts.
4.Do not operate in the rain or leave the product outdoors while it is raining.
5.The use of eye protection is recommended to protect against objects thrown by the cutting parts.
6.Keep others, including children, pets and
bystanders outside the 10 metre hazard zone. Stop the trimmer immediately if you are approached.
•WARNING: The cutting line continues to rotate after the machine has been switched off (Trimmers).
General
1.Never allow children or people unfamiliar with these instructions use the product. Local regulations may restrict the age of the operator.
2.Only use the product in the manner and for the functions described in the instructions.
3.Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine.
4.The operator or user is responsible for accidents or hazards occurring to other people or their property.
5.Keep bystanders away. Do not operate whilst people, especially children or pets are in the area.
Electrical Safety
1.The use of a Residual Current Device (R.C.D.) with a tripping current of not more than 30mA is recommended. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it.
2.Before use, examine cable for damage. If there are signs of damage or ageging, it must be replaced by the manufacturers service agent or a similar qualified person to avoid hazard.
3.Do not use the product if the electric cables are damaged or worn.
4.Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one.
5.Your cable must be uncoiled or unwound, coiled or wound cables can overheat and reduce the efficiency of your product.
6.Keep the cable clear of the cutting area and obstacles at all times.
7.Do not pull cable around sharp objects.
8.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.
9.Switch off, remove plug from mains and
examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Electrolux Outdoor Products replacement cable.
10.Always wind cable carefully, avoiding kinking.
11.Never carry the product by the cable.
12.Never pull on the cable to disconnect any of the plugs.
13.Use only on AC mains supply voltage shown on the product rating label.
14.Our products are double insulated to EN60335. Under no circumstance should an
earth be connected to any part of the product.
Cables
Use only 1.00mm2 size cable up to 40 metres length maximum.
Maximum rating:
1.00mm2 size cable 10 amps 250 volts AC
1.Mains cables and extensions are available from your local Electrolux Outdoor Products Approved Service Centre.
2.Only use extension cables specifically designed for outdoor use.
ENGLISH - 1
