SInstall required shield properly before using the unit.
SUse only specified blade or trimmer head; make sure it is properly installed and se- curely fastened.
SNever start engine with clutch shroud re- moved. The clutch can fly off and cause se-
rious injury.
SBe sure blade or trimmer head stops turning when engine idles.
SMake carburetor adjustments with the low- er end supported to prevent blade or trim- mer line from contacting any object. Hold
unit by hand; do not use the shoulder har- ness for support.
SKeep others away when making carbure- tor adjustments.
SUse only recommended McCulloch accesso-
ries and replacement parts.
SHave all maintenance and service not ex- plained in this manual performed by your au- thorised service dealer.
FUEL SAFETY
SMix and pour fuel outdoors.
SKeep away from sparks or flames. S Use a container approved for fuel.
S Do not smoke or allow smoking near fuel or the unit.
S Avoid spilling fuel or oil. Wipe up all fuel spills. S Move at least 3 meters away from fueling
site before starting engine.
S Stop engine and allow to cool before re- moving fuel cap.
S Always store petrol in a container approved for flammable liquids.
CUTTING SAFETY
WARNING: Inspect the area to be cut before each use. Remove objects (rocks, broken glass, nails, wire, string, etc.) which can be thrown or become entangled in the blade or trimmer head.
S Keep others including children, animals, bystanders, and helpers at least 50 feet (15 meters) away. Stop engine immediately if you are approached.
SAlways keep engine on the
SHold the unit firmly with both hands.
S Keep firm footing and balance. Do not overreach.
S Keep blade or trimmer head below waist level. Do not raise engine above your waist.
SKeep all parts of your body away from blade, trimmer head, and muffler when engine is running. A hot muffler can cause serious
burns.
SCut from your left to your right. Cutting on right side of the shield will throw debris away from the operator.
SUse only in daylight or good artificial light. S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
SAllow the engine to cool; secure unit before
storing or transporting in vehicle.
SEmpty fuel tank before storing or transporting the unit. Use up fuel left in the carburetor by
starting engine and letting it run until it stops.
SStore unit and fuel in an area where fuel va- pors cannot reach sparks or open flames
from water heaters, electric motors or switches, furnaces, etc.
SStore unit so line limiter cannot accidentally
cause injury. Unit can be hung by the shaft.
SAlways install transport guard on blade be- fore transporting or strorage.
SStore the unit out of the reach of children. S Secure the machine during transport. SPECIAL NOTICE: Exposure to vibrations through prolonged use of petrol powered hand tools could cause blood vessel or nerve dam- age in the fingers, hands, and joints of people prone to circulation disorders or abnormal swell- ings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An
ASSEMBLY
CARTON CONTENTS
Check carton contents against the following list:
SBrushcutter S Blade
S Cupped washer
S Large nut for installing blade S Trimmer head
S Combination shield S Bolt
S Handlebar
S Handlebar bracket cover
S Handlebar bracket cover screws (2) S Upper shoulder harness clamp
S Lower shoulder harness clamp
S Shoulder harness clamp screws (2)
SShoulder harness S Hex wrench
S Wrench
S Transport guard S Throttle cable clip
WARNING: Always stop unit and dis- connect spark plug before performing any as- sembly procedures.
WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
5