SERVICE AND ADJUSTMENTS

REPLACING THE LINE

1.Press the tabs on the side of the trimmer head and remove cover and spool.

5.When installing new line on an existing spool, hold the spool as shown.

6.Bend the line at the midpoint and insert the bend into the slot in the center rim of the spool. Ensure line snaps into position in the slot.

Slot

TabTab

Cover

Spool

2.Remove any remaining line.

3.Clean dirt and debris from all parts. Re- place spool if it is worn or damaged.

4.Replace with a pre-wound spool, or re- place line using a 25 feet (8 meters) length of 0.080 inch (2 mm) diameter line.

WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.

7.With your finger between the lines, wrap the lines evenly and firmly around the spool in a clockwise direction.

8.Position the lines in the guide slots. Guide slot

Guide slot

9.Place the spool in the cover as shown below.

15

Page 15
Image 15
McCulloch MC025, 966624901, 115376727 instruction manual Service and Adjustments, Replacing the Line