McCulloch MT705 manual Installing a PRE-WOUND Reel

MAINTENANCE AND REPAIR INSTRUCTIONS

3.Pull old line out of the line loading and line locking holes (Fig. 13 and 14).

4.Insert a piece of trimming line straight into one of the two eyelets in the outer spool. Push it up through the line loading hole in the inner reel (Fig. 13). Do not bend the line when inserting it into the eyelet.

Trimming Line

Eyelet

Line Loading Hole

Fig. 13

5.Insert the line into the locking hole (Fig. 14). Do not push the line more than a 1/2 inch (12.7 mm) into the line locking hole. The line will form a small loop (Fig. 14) when it is inserted correctly.

Line Locking Hole

Fig. 14

6.Pull the line from the outer spool until the line is tight against the inner reel (Fig. 15).

7.Repeat procedures 4-6 with the second piece of line.

8.Hold the outer spool. Wind the inner reel counterclockwise until approximately four (4) inches (102 mm) of line remain (Fig. 16).

NOTE: Do not wind the inner reel before installing the second piece of line.

Fig. 16

9.If winding the line becomes difficult or if the line jams, pull the ends of the line from the spool (Fig. 17). Continue winding the inner reel counterclockwise.

Fig. 17

INSTALLING A PRE-WOUND REEL

1.Turn the bump knob counterclockwise and remove the bump knob, spring and foam seal (Fig. 18).

Bump Knob

Foam Seal

Spring

Inner Reel

Fig. 15 Fig. 18

12