V-belts, Deck Belt, To replace deck belt | McCulloch 966564001

V-belts

MAINTENANCE

Parking Brake

Visually check that no damage is found on the lever, links, or switch belonging to the parking brake. Perform a standstill test and check that there is sufficient braking action.

To adjust the parking brake, contact the McCulloch service workshop.

WARNING!

Faulty adjustment can result in reduced braking ability and can cause an accident.

V-belts

Check every 100 hours of operation. Check for severe cracking and large nicks.

NOTE: The belt will show some small cracks in normal operation.

The belts are not adjustable. Replace belts if they begin to slip from wear.

Deck Belt

To replace deck belt

Deck belt removal.

1.Park on a level surface. Apply park brake.

2.Lower the deck to the lowest cutting position.

3.Disengage the clutch by sliding the blade control lever downwards.

4.Carefully lift the belt away from belt keepers and off deck pulleys and remove from deck.

5.Replace belt (refer to the belt routing decal on the deck) and re-engage clutch.

8050-005

Check for proper operation of parking brake

8058-074

Disengage clutch to replace deck belt

8058-071

Check deck belt for excessive wear

37

Image 37

McCulloch 966564001, ZM3016 BF manual V-belts, Deck Belt, To replace deck belt, Maintenance, Parking Brake

Contents

ZM3016 BF Operator Manual In order to implement improvements, specifications and designs can be altered without prior notification Contents Page Congratulations INTRODUCTIONGeneral Driving and Transport on Public Roads Manufacturing Number Good Service Xxxx xxxxxx symbols and decalsxxxxxxxxxxxxxxx IMPORTANT INFORMATION remove key before remove safetyperforming any Whole body Safety Instructions SAFETYSAFETY INSTRUCTIONS COULD THIS CUTTING MACHINE IS CAPABLE Always wear eye protection when operating machine Slope Operation Personal Safety Equipment Children There is risk for burns if touched Safe Handling of Gasoline Use protective glasses for maintenance work General Maintenance Use protective goggles Spark Arrestor Transport Control Locations CONTROLS 1.Forward 2.Neutral 3.Neutral slot, Neutral lock Steering Control Levers4.Reverse Parking Brake Ignition SwitchThrottle Control Refueling Choke ControlRisk for burns if touched Mower Deck Lifting Lever Fuel Shut Off ValveTracking Always use the high position F to transport Blade Control Lever Seat Adjustment LeverManual Transport the engine stopped the ignition key removed Training operationSteering To move forward and backward Starting the Engine Before Starting Move the throttle to the middle position IMPORTANT INFORMATION To remove cables, reverse order Jumper cables Running Operating on Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Schedule MAINTENANCE Clean/replace the spark plugs Check/adjust throttle cableCheck/adjust the mower deck Perform the 300-hourservice To clean battery and terminals BatteryReplacing battery Always use two wrenches for the terminal screws Tire Pressures Safety System Deck Belt V-beltsTo replace deck belt Blade replacement Belt installationEZT Belt Cutting Blades 1.Engage the parking brake Adjusting the Mower DeckLeveling Deck Removal and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster Wheels General LUBRICATION Front Wheel Bearings Front Wheel MountEngine Lubrication Steering Control Shafts Problem TROUBLESHOOTINGCause The engine seems weak storage ServiceWinter Storage SCHEMATIC Torque Specifications TECHNICAL DATAHEX HEAD CAP SCREWS U.S. Standard Hardware Engine ZM3016 BFTransmission RZ3019 BF Overall dimensionsEquipment Productivity USA Requirements CONForMITY CERTIFICATESCE Requirements SERVICE JOURNAL 25-HourService 100-HourService 50-HourService At Least Once Each Year 300-HourServicePage 03/19/10 P/N 115 349327R1