How to Connect using a two Amplifiers
Caution: The AC Power Cord should not be connected to the Power Amplifier until after the Loudspeaker Con- nections have been made. Failure to observe this could result in Electric Shock.
1.Prepare Loudspeaker cables by choosing one of the methods below:
Bare wire cable ends:
Carefully remove sufficient insulation from the cable ends, refer to figures 9, 10 & 11. If the cable is stranded, carefully twist the strands together as tightly as possible.
Post of the Power Amplifier number one.
6.Connect a Loudspeaker cable from the XRT1K MID Frequency COM
7.Connect a Loudspeaker cable from the XRT1K MID Frequency 8Ω (+) Binding Post to the (8 ohm) Binding Post of the Power Amplifier number two.
8.Tighten all of the Loudspeaker and Amplifier Binding Posts.
Figure 9 | Figure 10 | Figure 11 |
Note: If desired, the twisted ends can be tinned with solder to keep the strands together or attach spade lugs.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared section of the cable end into the terminal side access hole, and tighten the terminal cap until the cable is firmly clamped into the terminal so the wires cannot slip out. Refer to figures 12, 13 & 14.
McIntosh Power Amplifier number one
Figure 12
Figure 13 
Figure 14 
2.Remove the metal jumper between the Loudspeaker LOW Frequency COM
3.Remove the metal jumper between the Loudspeaker LOW Frequency 8Ω (+) Binding Post and MID Fre- quency 8Ω (+) Binding Post.
4.Connect a Loudspeaker cable from the XRT1K LOW Frequency COM
Notes: 1. It is important to maintain the correct polarity at both ends of the Loudspeaker cables.
2.For proper operation the metal jumpers must be installed between the Loudspeaker Terminal Posts as illustrated.
5.Connect a Loudspeaker cable from the XRT1K LOW Frequency 8Ω (+) Binding Post to the (8 ohm) Binding
10
