LIST OF COMPONENTS | USING YOUR DEEP FRYER |
|
|
| 6. | - |
|
| 5. | 3. | |
|
|
| ||
| 1. | 2. | 8. |
|
|
| - | ||
|
|
| ||
|
|
| 7. | |
|
|
|
| |
|
|
| 9. |
|
|
| 4. |
|
|
|
|
| 10. | - |
1. |
| Handle | 11. |
|
|
|
| ||
2. |
| Basket |
|
|
3. |
| Immersed heating element | - | |
|
|
|
|
4.Outer jacket
5.Filter lid
6.ON/OFF switch
7.Temperature control light
8.Temperature control knob
9.Control box housing
-
10.Cord storage area
11.Internal bowl
BEFORE FIRST USE | - |
-Remove the lid, basket, handle, controlbox and the bowl from the outer jacket.
-
-Clean the lid, basket, handle, bowl and the outer jacket in hot soapy water and dry
| thoroughly. | - | |
- | Do not immerse the controlbox in any liquid. | ||
|
DISMANTLING THE DEEP FRYER
- | Remove the controlbox from the appliance. | - |
| ||
| To do this, gently pull the controlbox |
|
| upwards. |
|
-Take the bowl with both hands and pull it up slightly.
-
ASSEMBLING OF THE DEEP FRYER
-Place the outer jacket on a heat resistant dry level surface.
-Replace the bowl until it rests on the top edge of the outer jacket.
We advise that you use liquid oil, which is recommended for deep fat frying.
Ensure the appliance is switched off. Slowly add the oil to the fryer untill the required level is reached (between the minimum and the maximum indications)
Set the temperature control knob to the temperature you require. Switch on the appliance the red ON/OFF lamp will switch on.
When the oil is heating, the green thermostatic light will be illuminated. When the oil reaches the set temperature, the light will go out. The thermostat will cycle on and off to indicate when the appliance is heating the oil and when the desired oil temperature has been reached.
For best results, always wait until the appliance is at the correct temperature before adding food.
Place the food to be fried carefully in the basket. With the handle attached to the basket, gently lower the basket into the oil. For"crispy" result, we recommend using the fryer without the lid. Be very careful of spitting hot oil.
Always switch off the appliance and unplug from the power supply after use or whilst unattended.
Should you accidentally switch ON the deep fryer without oil or fat or without the minimum amount of oil required, the deep fryer will automatically
If this happens, first
- Replace the controlbox. To replace the
-
This will reset the deep fryer. The deep fryer is now ready to use.
controlbox, firmly slide the controlbox down
-
the two grooves on the back of the outer jacket. The appliance will only operate when the control panel is correctly fitted to the outer jacket.
Should you wish to use solid fat, turn the temperature knob to its lowest position. Cut the solid fat into cubes of size
15