KEY TO THE MAIN COMPONENTS OF THE APPLIANCE
1.Adapter with cord
2.Charger jack
3.Comb
4.Scissors
5.Holder
6.Lubricating oil
7.Cleaning brush
8.Cutting head
9.Locking ring
10.On/Off button
11.Recharging indicator
12.Charger jack
13.Large comb, 4, 7, 10, 12 and 16 mm
14.Fine comb, 1 and 3 mm
Symbols on locking ring
Unlocked symbol
Locked symbol
Thinning symbol
PRIOR TO FIRST USE
Before using for the first time, fully charge the battery (See Battery Charging below), which takes approx.
USING THE APPLIANCE
The appliance is designed for cutting and trimming of hair and beard and can be used with or without a comb attachment, depending on the required length.
Fitting the comb attachment
•Fit the required comb attachment (13 or 14):
o Set the locking ring (9) so the unlocked symbol is level with the arrow on the appliance.
o Place the desired comb attachment over the cutting head (8) so the small pins on either side of the cutting head click into place in the small indentations on either side of the comb attachment.
o Remove the comb attachment by carefully pulling it away. The locking ring must be unlocked.
•Set the comb attachment to the desired cutting length by sliding it up and down the appliance until the arrow on the appliance is level with the desired length.
o The small comb attachment can be set to lengths of 1 or 3 mm and the large comb attachment can be set at 4, 7, 10, 12, 14 or 16 mm.
•Lock the locking ring by turning it until the locking symbol is level with the arrow on the appliance.
•Switch on the appliance using the on/off button (10) and commence trimming.
Trimming and shaving without a comb attachment
The cutting head is used to trim the beard and shave the head, e.g. in the neck. Carefully slide the appliance over the skin with slow even movements at a low angle and without using pressure.
•Take care not to push in the direction of the cutting head or to push the cutting head sideways.
•Caution! The cutting head is very sharp, so be careful!
Trimming with a comb attachment
Trim the beard by using the appliance with a decreasing cutting length until the beard has the desired length.
19
