Melissa 640-043 manual Assembling The Vacuum Cleaner, Removing The Hose, Floor Brush Use

-Do not use the appliance on wet surfaces.

-Do not obstruct the air intake or the air outlet vents.

-Do not use the appliance to vacuum needles, drawing pins or string.

ASSEMBLING THE VACUUM CLEANER:

Always remove the plug from the power socket before fitting or removing accessories.

Fitting the tube:

-Press the buttons on the end of the tube and insert the tube into the air- intake.

REMOVING THE HOSE:

Remove the plug from the power socket. To release the hose, press the buttons on the end of the hose and pull the hose firmly from the air intake duct.

FLOOR BRUSH USE

-Press the left button on the floor brush down for cleaning hard floors.

-Press the rigth button on the floor brush down for cleaning carpets.

INSTRUCTIONS FOR USE

-Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Do not extend the cable beyond the red mark.

-To rewind the power cable, press the rewind button with one hand, and guide the cable with the other hand to ensure that it does not whip causing damage.

-Press the ON/OFF button to switch the appliance on.

ADJUSTMENT OF THE TELESCOPIC TUBE

You can adjust the lenght of the telescopic tube by holding the black ring and pulling or pushing the part with the locking mecanism. It can be unlocked just as easily and brought into a different position.

REPLACING THE DUSTBAG:

-Remove the hose.

-Lift the front cover and move the lock that holds the dust bag forward. Now the dust bag can be removed.

-Place a new dustbag and move the lock back over the dustbag so it sits firm in its place.

REPLACING THE MOTORFILTER

the motorfilter is the filter placed behind the dustbag.

-Take the filter holder out and remove the filter.

-Clean the filterholder before a new filter is placed in it.

-Push the filter holder with the new filter back in place.

REPLACING THE MICROFILTER

The microfilter is the filter placed on the back of the vacuum cleaner:

Press the release-button on the grid and pull it out at the same time.

Remove the microfilter and insert a new microfilter.

Insert the grid back in place.

15