8
6. Press Power Switch ON.The LED Indicator Light will turn red.
CAUTION: Avoid contact with heated water.
IMPORTANT: Do not remove Thermal Mugs until the LED
Indicator Light has turned OFF.The LED Indicator Light will
turn OFF approximately two minutes after brewing is
complete. This delay will allow the last drops of coffee to flow
into the Thermal Mugs.
7. After LED Indicator Light turns off, Thermal Mugs may be
safely removed.
8. If brewing more than one cycle, allow unit to cool for 10
minutes between cycles.
Helpful Hints for Brewing
• Always use fresh, cold water for brewing. In areas with hard
water or where water contains a high mineral content, use cold
filtered water for optimal coffee taste.
• For best results, use Melitta®#2 paper cone filters and Melitta®
Premium Coffee.
• The markings on the Water Level Indicator reflect the quantity
of fresh water to be used.The quantity of brewed coffee is less
because the coffee grounds absorb water.
Programming a Delayed Brew
1. Press the PROG button twice, “SET TIMER” will be displayed
in the bottom center of the Display Window.
2. Using the HR and MIN button, set the time you wish the coffee
to begin brewing. Once the time is set, the display will return
to the time of day automatically after 8 seconds, and then
“SET TIMER” will disappear. You may also press the PROG
button to make the display return to the time of day.
3. Press AUTO button, LEDIndicator Light will be green to
indicate the timer has been set for delayed start.
Note:To cancel the delayed start, press AUTO once again, the
LED Indicator Light will go off and the delayed start program
will be cancelled.
4. When the delayed start program has reached the preset time,
the LED Indicator Light will change to red and the brewing will
start.
Note: During the auto-brew program, you may start brewing at
once by pressing the ON/OFF button.