from the wall socket when it is not in use.
Before Use
1.Read these instructions carefully with the illustrations before using the appliance for the first time.
2.Before connecting the kettle, check that the voltage indicated on the rating label (underneath of base) corresponds with the mains voltage in your home.
3.The kettle will switch off automatically when the water has boiled. You can switch the kettle off manually before boiling by using the switch.
4.After the kettle has switched off automatically (or has been switched off manually) it will need some time to cool down. After
5.The kettle is protected against dry- boiling. This happens when the kettle is switched on with insufficient water. The kettle will switch off by means of a safety cut out switch to prevent the element from over heating.
6.If the kettle runs dry while operating, allow to cool down for 15 minutes before refilling with cold water. The safety
7.Place the appliance on a stable, flat surface. Ensure that the kettle cannot fall into water.
8.Never immerse the kettle in water. Do not allow water to penetrate the electrical parts inside the kettle.
9.Prevent children from pulling the power cord, or knocking
the kettle over.
10.Before cleaning the kettle, make sure the kettle is disconnected from the wall socket and that it
has cooled down.
11.The kettle may be cleaned with a damp cloth.
12.Discard the very first water boiled from
this kettle.
13.Only use the base unit supplied with this product. If a replacement is required only approved components must be used.
Operating Instructions
1.Make sure that the filter is pressed into the holes of the lid tongue and fitted correctly.
2.Fill the water into the kettle making sure that the water capacity is not lower than the “MIN” mark and does not exceed the “MAX“ mark.
3.Ensure the lid is closed properly.
4.Insert plug into wall socket.
5.Put the kettle body onto the base.
6.Switch the appliance on, making sure that the indicator light is illuminated.
7.When the water is boiled, the appliance will automatically switch off and the indicator light will switch off.
8.If the water has to be reheated, please wait several minutes before reboiling.
Cleaning Instructions:
Always disconnect the kettle from the wall socket when cleaning.
A. Kettle Body Cleaning: Scaling or furring up is a common problem. A water purifier and periodic cleaning is recommended.
Scaling will damage the function of the heating element and impair the function of the dry boil protector.
•To clean the inside of the kettle, fill with water, then add 200ml of white vinegar and let the mixture boil.
•Unplug the appliance, pour away this mixture.
•
B. Filter Cleaning:
•Take out and place the filter under a tap and rub gently with your fingers.
