Mellerware 23810 Tips and safety warnings, Before using the appliance for the first time, control

Models: 23810

1 8
Download 8 pages 32.96 Kb
Page 4
Image 4
Tips and safety warnings

Tips and safety warnings

-Please read these instructions carefully before us- ing the appliance and keep them for future refer- ence.

-Unpack the appliance and check it is in perfect condition and working order, as any factory fault or damage caused by transport is covered by the MELLERWARE guarantee.

-This device has been designed for household use, not for commercial use.

-Do not leave the appliance without supervision if you are not going to use it immediately. This will save energy and prolong the working life of the appliance.

-Keep the appliance out of the reach of children. -The appliance must not be connected to the mains while the boiler is being filled (Fig. 1). -Before connecting the appliance to the mains, ensure the supply voltage is the same as that marked on the appliance. English -The water filling inlet must not be open during operation.

-This appliance must be connected to an electrical socket with an earth connection.

-Any improper use or failure to comply with the in- structions for use will invalidate the warranty and free the manufacturer from any liability concerning the appliance.

-IF THE IRON IS IN ITS HOUSING AT MAXIMUM TEMPERATURE FOR A LONG TIME, THIS MAY CAUSE ALTERATIONS TO ITS COLOUR, BUT THIS HAS NO EFFECT ON THE PROPER OPERATION OF THE APPLIANCE.

-The appliance must be used and placed on a flat, stable surface

-When placing the appliance on its support, make sure the surface on which the support is fitted is stable.

-Do not use the appliance if it has been dropped, if there are visible signs of damage or if it leaks.

Before using the appliance for the first time

parts of the iron have been slightly greased. They can therefore give off steam on first use, but this steam will disappear after a short time.

Practical tips

-Keep the sole plate smooth, do not apply it to metallic objects (i.e., to the ironing-board, butons, zips...).

-Fit the iron in its housing (L) for transport and stor- age, in order to improve its stability.

-To avoid burns, do not lean Bravissimo 2 Pro’s iron on its back.

Steam ironing

When you start to iron, proceed as follows:

-Unscrew the cap (F) and fill the boiler with water, using a jug (Fig. 1) (if you fill it with hot water, the appliance will be ready for use sooner).

-Even if the boiler has a certain level of water, it is always recommended to fill it to the top for a lon- ger range, thanks to its large 1l capacity.

-Carefully close the cap (F), screwing it to the end.

-Place the boiler on a flat , stable surface. -Plug the appliance into the mains.

-Switch on the boiler and the iron by pressing the relevant switches (B) and (A). The corresponding LEDs will light (Fig. 2).

Thermostat

Type of

Steam

control

fabric

position

 

 

 

 

 

 

Nylon / Silk

No

••

Wool

No

•••

Cotton, Linen

Yes

 

 

 

 

 

This professional iron works with tap water. However, the use of distilled water is recomended in areas with a high lime level in the water. Some

It is recommended not to use steam in the • and •• thermostat positions, as water could drip.

MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 4

7/15/2009 4:32:44 PM

Page 4
Image 4
Mellerware 23810 Tips and safety warnings, Before using the appliance for the first time, Practical tips, Steam ironing