Mellerware 35100 manual Installation, Operation, Cleaning And Maintenance, Warnings, Safety Device

Models: 35100

1 4
Download 4 pages 2.39 Kb
Page 3
Image 3

CAUTION

1Read all instructions before using the fan heater.

2Only connect the fan heater to a single-phase socket with main voltage as specified on the rating plate.

3This appliance meets the electromagnetic compatibility requirements specified in EN 55104/95 with regard to interference with radio and TV sets.

4Do not leave your home while the appliance is in use. Ensure that the switch is in the OFF (0) position and that the thermostat is in the minimum position. Always unplug the appliance.

5Keep combustible material such as furniture, cushions, bedding, paper, clothes, curtains etc. at least 100cm away from the fan heater.

6If wall mounted do not fix to combustible material such as wooden, synthetic or plastic surfaces. Do not hang anything on or in front of the fan heater.

7Always unplug the heater when not in use. Do not pull the cord to unplug the heater.

8Keep the air inlet and outlet free from objects; at least 1m in front and 50cm behind the heater.

9Do not install the heater below an electical socket.

10Do not let children or animal touch or play with the fan heater. Pay attantion! The air outlet gets hot during operation (more than 80°C).

11Do not cover, if covered there is a risk of overheating.

12Do not use the fan heater in the immediate surroundings of a bath, shower or swimming pool.

13Do not use the fan heater in rooms with explosive gas or while using flammable solvents, varnish or glue.

14In case the power cord is damaged send it to the nearest after sale service recommended by the supplier for the replacement.

INSTALLATION

This appliance requires no installation and should be used soley as a portable device.

OPERATION

-Turn the thermostat knob (right) in a clockwise direction until it reaches the maximum setting.

-Summer service (ventilation only): turn the knob to

fan setting

-Heating at reduced power; turn the thermostat knob (right) to setting (1000w)

-Heating at full power; turn the thermostat knob (right) to setting •• (2000w)

-Switching off; turn the switch knob (left) to setting 0.

Regulating the thermostat:

When the room has reached the desired temperature, turn the right thermostat knob in an anti-clockwise direction up to where the appliances switches off and not beyond.

The temperature is “fixed” in this way and will be automatically regulated and kept at a contant level by the thermostat.

CLEANING AND MAINTENANCE

Before cleaning always remove the plug from the electrical socket.

Clean the air intake and outlet grilles frequently.

Never use abrasive solvents or powders.

WARNINGS

Do not use the heater to dry laundry.

Never obstruct the intake and outlet grilles (danger of overheating).

The appliance must be positioned so that the switches and other controls can not be reached by children or persons using the bath tub or shower.

In case the power cord is damaged send it to the nearest after sale service recommended by the supplier for the replacement.

Do not use in rooms with less than 4m² floor area.

SAFETY DEVICE

The heater is fitted with a safety device which will switch the appliance off in case of accidental overheating. (eg: obstruction of air inlet and outlet grilles, motor turning slowly or not at all.)

To reset, disconnect the plug from the mains power for a few minutes, remove the cause of overheating then plug the appliance in again.

Page 3
Image 3
Mellerware 35100 Installation, Operation, Cleaning And Maintenance, Warnings, Safety Device, Regulating the thermostat