Mellerware 3 5 2 0 02000W manual Additional Warnings For Heaters, Instructions For Use

Models: 3 5 2 0 02000W

1 4
Download 4 pages 44.64 Kb
Page 3
Image 3
ADDITIONAL WARNINGS FOR HEATERS:

ADDITIONAL WARNINGS FOR HEATERS:

1.Read all instructions before using the fan heater.

2.Only connect the fan heater to a single-phase socket with a main voltage as specified on the rating plate.

3.This appliance meets the electromagnetic compatibility requirements specified in EN55104/95 with regard to interferance with radio and TV sets.

4.Do not leave your home while the appliance is in function, ensure that the switch is in OFF (“O”) position and that the thermostat is in minimum position. Always unplug the appliance when not in use.

5.Keep combustible material such as furniture, bedding, cushions, clothes, curtains, paper etc. at least 100cm away from fan heater.

6.If wall mounted do not fix to combustible materials such as wood, synthetic or plastic surfaces. Do not hang anything from or in front of the fan heater.

7.Always unplug the heater when not in use. DO NOT pull the cord to unplug the heater.

8.Keep the air inlet and outlet free from objects at least 1m in front and 50cm behind the heater.

9.DO NOT use the heater below an electric socket.

10.DO NOT let children or animal play with the heater. Pay attention! The air outlet gets hot during operation (more than 80°C)

11.DO NOT COVER. If covered there is a risk of overheating.

12.DO NOT use this fan heater in the immediate surroundings of a bath, shower or swimming pool.

13.DO NOT use the heater in room with explosive gas or while using inflammable solvents, varnish or glue.

14.Keep the fan heater clean. DO NOT allow any objects to enter the ventilation or exhaust openings as this may cause electric shock, or fire or damage to the heater.

15.Always use the heater in an upright position.

16.DO NOT use the heater to dry laundry.

17.NEVER obstruct the intake and outlet grilles (danger of overheating).

18.The heater must be at least 50cm from furniture and other objects.

19.DO NOT use the appliance in room with less than 4m² floor area.

The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (eg: obstruction of intake/outlet grilles, motor turning slowly or not at all).To reset, disconnect the plug from the power for a few minutes, remove the cause of overheating and plug the appliance in again.

INSTRUCTIONS FOR USE:

This appliance requires no installation and should be used solely as a portable appliance.

Summer Service (ventillation only): turn the knob to fan setting.

1Turn the thermostat knob (left) in a clockwise direction until it reaches the maximum setting.

2Heating at reduced power: turn the right knob to setting I (1000w).

3Heating at full power: turn the right knob to setting II (2000w).

4Switching off: turn the left knob to setting “O”.

1

 

2

3

 

4

 

REGULATING THE THERMOSTAT:

When the room has reached the desired temperature turn the left thermostat knob in an anti-clockwise direction up to the point where the appliance switches off and not beyond.

The temperature is fixed in this way and will be automatically regulated and kept at a constant level by the thermostat.

CLEANING AND MAINTENANCE:

Before cleaning always remove the plug from electrical socket.

Clean the air inlet/outlet grilles frequently.

Never use abrasive powders or solvents.

Page 3
Image 3
Mellerware 3 5 2 0 02000W manual Additional Warnings For Heaters, Instructions For Use, Regulating The Thermostat