Memorex MB2186A manual Operation, Echo Control, Auto Vocal Control, Mic On/Off Switch, Karaoke

Models: MB2186A

1 24
Download 24 pages 52.64 Kb
Page 8
Image 8
ECHO CONTROL

MKS5009.OM.QXD 7/22/03 1:35 PM Page 7

ECHO CONTROL

1

Rotate the ECHO control clock- wise to increase the echo or counterclockwise to decrease the echo.

OPERATION

AUTO VOCAL CONTROL

1

When the VOCAL feature is activated, the vocals on a multiplex recording are muted as soon as the singer begins singing into the microphone. When the singer stops singing, the vocals are automatically unmuted. Adjust the AUTO VOCAL control for the best balance between playback and microphone levels.

IMPORTANT: This feature only works with multiplex CDs.

MIC ON/OFF SWITCH

BALANCE CONTROL

(KARAOKE)

1

1

TONE CONTROL

1

To turn the microphone on, slide the ON/OFF switch, located on the side of the microphone, to the ON position. To turn the microphone off, slide the ON/OFF switch to the OFF position.

Rotate the BALANCE control clockwise to hear the music and vocals or counterclockwise to hear the music only.

NOTE: To use the BALANCE control, a karaoke tape or CD+G disc must be used.

Rotate the TONE control clock- wise to increase the tone response or counterclockwise to decrease the tone response.

CONNECTING THE MICROPHONE(S)

This unit has two microphone jacks, use one with the supplied microphones, which will allow you to sing along with your favorite songs. Before connecting, make sure the MIC VOLUME Controls are set to minimum.

If only connecting one microphone, connect it to the MIC1 jack.

HEADPHONE JACK

For private listening, connect low impedance 3.5mm (32 ohm) stereo headphones (not included) to this jack. The speaker is disconnected when using the headphones.

7

Page 8
Image 8
Memorex MB2186A Operation, Echo Control, Auto Vocal Control, Mic On/Off Switch, Karaoke, Tone Control, Headphone Jack