Memorex MPD8846 operating instructions Radio Operation, To Listen to the Radio

MPD8846.O/M.QXD 2/24/03 7:25 AM Page 6

RADIO OPERATION

TO LISTEN TO THE RADIO

1 ￿ ￿

2 ￿ ￿ ￿

Set the VOLUME control ❶ to minimum and plug the headphone into the PHONES jack. Press the PLAY/PAUSE ( ) /POWER ON button ❷ to turn the unit on.

Slide the FUNCTION switch ❶ to the RADIO position. Press the MENU/ESP/BAND button ❷ to select a band (AM or FM). If listening to FM, press the MODE/ button

❸to select Stereo or Mono.

3 ￿ ￿

4 ￿ ￿

Press and release the Skip/TUNING DN

❶ or UP ❷ button to tune a station. Press and hold the Skip/TUNING DN ❶ or UP ❷ button for Auto Scan tuning (see below).

Adjust the VOLUME control ❶ and DBBS switch ❷ as desired. If FM STEREO reception is weak/noisy, press the MODE/  button ❸ to Mono, in this case the reception will be monaural.

5

To turn the radio off, press the STOP (■)/POWER OFF button.

ANTENNAS

AM – This unit has a built-in ferrite bar antenna, which provides adequate reception in most areas. If reception is weak, turn the unit to improve reception.

FM – The headphones act as an antenna for FM. Extend the headphone wire for best FM reception.

AUTO SCAN

Press and hold the Skip/TUNING DN or

UP button for approximately one second and the unit will automatically search for the next available station.

6