Memorex MVDP1075 manual Connecting the DVD to a Home Theatre System Audio Jack

CONNECTION (CONTINUED)

CONNECTING THE DVD TO A HOME THEATRE SYSTEM (AUDIO JACK)

From Audio Out

Place the subwoofer, front, rear and center speakers in locations as shown/described here. After correctly positioning the speakers, perform the Tone Test on the AV Amplifier and adjust the Volume control(s) until the desired sound is achieved. For best results, sit in the viewing position and have someone adjust the volumes for you; this will enable you to set the optimal levels.

From Video Out

Audio Cable (Included)

Video Cable (Included)

To Video

Input

3

12

To Audio Inputs

9

5

4

NOTE: The rear speakers can also be located on the side wall facing the viewing position and each other. Make sure the viewing position is located between the two speakers in this case. Experiment to find optimal position.

1.Front Left Speaker

2.Television

3.Center Speaker–can be located on top or below the Television.

4.Sub-woofer–can be located anywhere in the room.

5.Front Right Speaker

7 6 8

6.Viewing/Listening Position–The best listening position is obtained by positioning the chair, sofa, etc. in the middle of all the speakers.

7.Rear Left Speaker

8.Rear Right Speaker

9.AV Amplifier w/Dolby Digital Decoder

NOTES FOR CONNECTING TO A TV:

• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.

• When connecting the DVD, refer to the owner’s manuals for the TV and the audio system, as well as this manual.

• When connecting, make sure the power is off and all units are unplugged before making any connections.

• Connect the DVD player to your TV directly. If you connect the DVD player through a VCR, the playback picture will be distorted because DVD video discs are copy protected.

14