Meridian Audio 565 To set up a speaker output, To change the settings for a speaker, To select the output type

Configuring the digital surround processor
29
To set up a speaker output
●Switch off the 565, using the power switch on the back panel.
●Switch off any power amplifiers that are connected to the 565.
●Switch on the power again while holding down the Source
key on the front panel.
The display will show:
Speaker Set
and then after a short delay:
1 Main Left
●Press Source to step between the different speakers
specified in the layout you have chosen.
●Change the settings for each speaker as described below.
To change the settings for a speaker
●Press Source until the name of the speaker output you want
to adjust appears.
For example:
1 Main Left
If the speaker output does not appear check that you have
chosen the correct layout; see Specifying the speaker layout,
page 22.
To select the output type
●Press > until you see a display
such as:
1 Meridian
The number specifies the number of the output, and
corresponds to the labelling on the analogue or digital outputs
on the back panel.
The option specifies the type of speaker you are using, and
whether you are using the analogue or digital output connection.