1 1
I n s t a l l i n g t h e
C D p l a y e r
To connect to other Meridian G Series, 500 Series, or 800 Series equipment
G07/G08 | G Series, 500 Series, or 800 Series unit |
COMMS | COMMS |
COMMS LEAD | COMMS LEAD |
In a system of Meridian products, one of the products acts as the controller for the system, receiving
The following procedure should be used to set up the Comms correctly between several products:
•Connect one of the DIN COMMS sockets on the back panel of the CD player to one of the COMMS sockets on another G Series, 500 Series, or 800 Series unit, using the Comms leads provided with the products.
The sequence in which you connect the units is not important.
•Switch all the units to standby.
•Press Clear (MSR+).
Each unit will display:
Auto
One unit will then be designated as the controller, and display:
Con.
All the other units will be configured as
Not Con.
If for any reason the automatic setup does not work, make sure you are operating the MSR+ from a position where all the units can receive the
If this fails:
•Restore the default operation by selecting one of the standard types; see Resetting the product, page 13.
Note: Do not, under any circumstances, connect any equipment other than Meridian G Series, 500 Series, or 800 Series to any socket marked COMMS on the back of the product.