SPEAKERS
10%100% FX MIX
RETURN
MUTE
SPKR 
ON
SILENT RECORDING
8 OHM
COMBO
WARNING: To reduce risk of fire or | WARNING: To reduce risk of fire or electric |
electric shock, replace fuse with | |
same type and rating only. Do not | shock, Do not remove cover. No user- |
expose this unit to rain or moisture. | serviceable parts inside. Refer |
| servicing to qualified personnel. |
4 OHM | 4 OHM |
USE WITH 8 OHM SPEAKERS
FUSE:
This is the A.C.’s ( Alternating Current ) main fuse and provides protection from outside A.C. fluctuations, as well as power tube failure damage. Should the FUSE blow, replace it with the same rating in a slo- blo type package. The domestic U.S. version requires a 2 Amp
power tube is going bad or is arcing you will see it! Flip the STANDBY switch to STANDBY immediately
and replace the faulty power tube and the fuse if necessary. If you see nothing abnormal as you lift the STANDBY switch, it is possible that a power tube shorted temporarily and blew the FUSE. If this is the case it may work again normally. To be extra safe you may want to replace all power tubes in the troubleshooting tradition and save
the replaced set as spares. Carry along a few extra fuses for they too could be worth their weight in gold some day.
WARNING:
Unplug power before replacing fuse or removing bolts mounting chassis.
| POWER |
| FUSE |
120 V~ |
| 2 A | |
| SLO | ||
| 2 A |
| BLO |
|
| ||
FOOTSWITCH SOCKET BELOW 
2A S.B.
USE
F
E F
SU
RECORD / PHONES
STEREO OR MONO
RECORD / PHONES:
This jack provides
The send level strength is determined by the GAIN and MASTER controls. From this jack, adequate signal level will be available to you for most of your recording needs and live direct performances.
WARNING: | 2A S.B. |
| |||||
Unplug power | US | ||||||
before replacing | |||||||
fuse or removing | F E | ||||||
bolts mounting |
| ||||||
chassis. |
|
|
| F | PREAMP PATENT | ||
|
|
|
|
|
| ESU | 4,701,957 |
|
|
|
|
|
|
| |
| POWER |
| FUSE | RECORD / PHONES |
| ||
|
|
| |||||
|
|
|
|
|
|
| |
120 V~ |
| 2 A | FX | ||||
| SLO | STEREO OR MONO | SEND | ||||
| 2 A |
| BLO |
|
| ||
|
|
|
| ||||
FOOTSWITCH |
|
| |||||
SOCKET |
|
|
|
|
| ||
|
|
|
|
| |||
BELOW |
|
|
|
|
| ||
|
|
|
|
| |||
control being utilized regardless all other controls are inactive.
|
| FX LOOP: SEND & RETURN |
|
| These two 1/4" jacks are the patch point for external effects. The Effects Loop is |
| FX MIX | wired in parallel with the normal signal. Connect the SEND jack of the |
10% | your Effects Input jack. Connect the RETURN jack of the | |
100 % |
| |
| RETURN | of your effect unit. The Effects Loop is a patch point between the |
|
| section. Therefore, the RETURN jack can double as a “Power Amp Input” jack. |
When the RETURN is used as an input, the
PAGE 7
