10.Connect the other end of the small diameter suction hose (43 mm ∅) (13) to the blade guard.

13

14

11.Hang the small diameter suction hose to the support bracket (14).

12.Connect the long suction hose (100 mm ∅) (15) to the planer/thick- nesser’s suction port.

15

13.Put handle (16) on the selector and secure with screw.

16

14.Bend the spring steel ring of the dust bag (17) inward and fit inside the receiver (18), up against the stop.

17

18

 

15.Plug the dust collector’s short cable into the left outlet (19) of the dust collector.

19 20

16.Connect the combination machine’s power cable plug to the right outlet (20) of the dust collector.

17.Connect the long power cable to a mains outlet.

4. Operation

Commissioning

1.Set the selector:

−Selector in upper position: collection for circular saw and spindle moulder.

−Selector in lower position: collection for planer/thicknesser.

2.Start dust collector.

3.Start woodworking machine.

Stopping

1.Switch woodworking machine OFF.

2.Switch dust collector OFF.

ENGLISH

Relocation

1.Pull handle (21) out.

21

2.With the handle lift the complete unit, until the wheels touch the floor.

3.Roll unit to the desired location.

5.Maintenance

Check the dust bag periodically. If the dust bag is filled:

1.Unplug the dust collector.

2.Open the service door.

3.Push the spring steel ring inward and remove the dust bag from the receiver.

4.Dispose of the dust bag’s contents in an ecologically safe way.

5.Replace the dust bag (see Assem- bly) and close the service door.

6.Technical Specifications

Power supply

230 V / 1 ~ 50 Hz

Power input P1:

0.62 kW

Power output P2:

0.37 kW

Total power input P1

(when operated with Combination

machine Multi 180A):

1.72 kW

Mains fuse:

16 A, time-lag

Degree of protection:

IP 44

Suction capacity:

600 m3/h

Vacuum:

1000 Pa

Dust bag capacity:

68 litres

Suction port Ø: 2 x 100 mm / 1 x 43 mm Dimensions (L x W x H):

 

760 x 760 x 500 mm

Weight:

48 kg

Noise emission:

see combination machine

5