2 Standard Delivery
Saw blade TCT 300x2.6/1.8x30 mm 28 alternate bevel teeth
Riving knife 2.5 mm
Saw blade guard
Rip fence
Mitre fence
Dust extraction port with hoses
Push stick
Tool set
Operating instructions
3 Installation
Place machine upside down on two battens to install the workstand. Do not tighten screws fully before all parts have been installed.
Install suction port to chip case. |
| Place spiral hose Ø 100 mm onto suction | Install rear panel (with hole) between the | |
Use 3 each |
| port and secure with hose clamp Ø 100 | side panels. | |
hex. head screw M 6x16 |
| mm. Install both side panels, using 4 each | Use 6 each | |
serrated lock washer Ø 6.4 |
| hex. head screw M 6x16 | hex. head screw M 6x16 | |
hex. nut M 6 |
| serrated lock washer Ø 6.4 | serrated lock washer Ø 6.4 | |
|
| hex. nut M 6 | hex. nut M 6 | |
|
|
|
|
|
|
|
|
|
|
Install dust collection port into hole of the rear panel with 3 each
hex. head screw M 6x16 serrated lock washer Ø 6.4 hex. nut M 6
Place the spiral hose on the dust collection port and secure in place with the second hose clamp Ø 100 mm.
Install the workstand's front panel. Use 6 each
hex. head screw M 6x16 serrated lock washer Ø 6.4 hex. nut M 6
Put a hex. nut M 10 on the threaded bolt of all 4 adjustable feet.
Install feet into tapped bushes M 10 located on each corner.
Now tighten all screw joints fully, then stand machine on its feet. Place side panels lids into the panel openings.
17