Metra Electronics 99-7006 ALL Vehicles, Center console Radio trim bezel, See Fig. a

ALL VEHICLES

1

Center console

Radio trim bezel

3

Fig. A

Fig. B

IF AN EQUALIZER WILL BE INCLUDED: Slide the aftermarket equalizer into the back of the Radio Housing. Using the hardware included with the equalizer, mount the unit to the kit.

(see Fig. A)

IF AN EQUALIZER WILL NOT BE INCLUDED: Snap the Equalizer Dummy Plate into the Radio Housing. (see Fig. B)

Disconnect the negative battery terminal to prevent an accidental short circuit. Slide the front seats forward. Remove (1) cover cap and (1) Phillips screw from each side of the center console. Unclip the cupholder/ashtray assembly from the center console and remove (2) Phillips screws exposed. Unclip the radio trim bezel and remove (2) Phillips screws exposed. Unscrew the gear shifter knob. Disconnect the cigarette lighter and light wiring. Lift up on the center console and remove. Remove (4) Phillips screws securing the factory head unit and disconnect thewiring.

2

Fig. A

Fig. B

2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft

nuts. (see Fig. A)

DIN HEAD UNITS: Cut and remove the shaft supports from the Radio Housing. Slide the DIN cage into the Housing and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)

1

4

A

B

C

D

A)Strip wire ends back ½"

B)Twist ends together

C)Solder

D)Tape

Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).

5

Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit assembly to the sub-dash with (4) Phillips screws previously removed in step #1.

2