
6
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the dash. Metra recommends making connections as shown using the supplied wire harness. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).
Right Front + | Gray |
Right Front | Gray/Black |
Left Front + | White |
Left Front | White/Black |
Right Rear + | Violet |
Right Rear | Violet/Black |
Left Rear + | Green |
Left Rear | Green/Black |
12 Volt Power | Red |
Memory | Yellow |
Ground | Black |
Power Antenna | Blue |
Dimmer | Orange/White |
Amp | Blue/White |
NOTE: Ground head unit to vehicle
KIT FEATURES
Shaft and DIN unit provisions
Various mounting depth alternatives
Incorporates factory climate controls into installation
KIT COMPONENTS
Integrated
Mounting Kit
99-5720
INSTALLATION
INSTRUCTIONS
APPLICATIONS |
| |
CAR |
| PAGE |
FORD |
| |
Escort |
| |
Escort ZX2 |
| |
ZX2 |
7
Fig. B
DIN HEAD UNITS:Slide the DIN cage into the Integrated Mounting Kit and secure by bending the metal locking tabs down.Slide the aftermarket head unit into the cage until secure.(see Fig. B)
3 | Rev. |
Speaker
Harness
TOOLS REQUIRED
Cutting tool
MERCURY |
|
Tracer |
* Note: Metra’s
www.metraonline.com
© COPYRIGHT