Radiance Multi-Rate Line Card 11
Install the SFP Optics
The R380 line card requires two small form-factor pluggable (SFP)
optics. Optics are shipped separately. The table below lists the recom-
mended optics to use based on the network protocol and fiber type.
scitpOPFSdednemmoceR
locotorP epyTrebiF
edomitluMedomelgniSMDWBMDWC
3-SD2M-082002-382Oxx-08-384O
0-MTS/1-CO2M-082002-382Oxx-08-384O
/tenrehtEtsaF IDDF 2M-0820 04-182O 08-182O 02-3820
13-02-383O 55-02-383O xx-08-384O
1-MTS/3-CO2M-0820 04-182O 08-182O 02-3820
13-02-383O 55-02-383O xx-08-384O
NOCSE5M-292O 02-392O 01-3A2O xx-04-314O xx-08-314O
4-MTS/21-CO5M-292O 02-392O 01-3A2O xx-04-314O xx-08-314O
X1lennahCerbiF5M-1120 xx-112O 01-3A2O 13-01-113O 94-01-113O xx-04-314O xx-08-314O
tenrehtEtibagiG5M-1120 xx-112O 01-3A2O 01-122O
13-01-113O 94-01-113O
xx-08-114O xx-04-314O xx-08-314O
X2lennahCerbiF5M-122001-122O xx-04-314O xx-08-314O
61-MTS/84-CO01-3A2O xx-04-314O xx-08-314O
Before installing the SFP module, make sure the bail latch is closed, as
shown below. Do NOT open the bail.
SFP
SFP
CLOSED
BAIL LATCH
POSITION
DO NOT
OPEN
BAIL LATCH
To install the optics, align the SFP module so the receiver (▲) is
positioned above the transmitter (▼). For a BWDM module, align it so
the visible part of the circuit board located at the back of the module is
to the right. Slide the module into the empty slot. Push the SFP firmly
in place. Remove the protective covering on the connector.
3