Metrologic Instruments IS3480 Full Speed or Low Speed USB (Integrated)

10
INSTALLATION
Full Speed or Low Speed USB (Integrated)
1. Turn off the host device.
2. Plug the male 10-pin RJ45 end of
the USB PowerLink cable into the
10-pin socket on the IS3480.
3. Plug the other end of the USB
interface cable into the host
device’s USB port.
4. Plug the external power supply in
to the power jack on the USB
PowerLink cable.
Check the AC input
requirements of the power
supply to make sure the
voltage matches the AC
outlet. The outlet must be
located near the equipment
and be easily accessible.
5. Connect AC power to the
transformer.
6. Turn on the host device.
Plugging the scanner into the USB port of the PC does not guarantee
that scanned information will appear at the PC. A software driver and
correct configuration setting are also required for proper
communication to occur.
Caution:
To maintain compliance with applicable standards, al l circuits connected to the scanner
must meet the requirements for SELV (Safety Extra Low Voltag e) according to EN/IEC
60950.
To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm
EN/IEC 60950, the power source should meet applic able performance requirements for
a limited power source.
Figure 8.