Attaching the Scanner to the Stand and Work Surface
The scanner can be positioned in a vertical orientation with the Metrologic stand (Part #45478). To attach the unit to the stand and work surface purchase the following: four
1.Lay the scanner face down on a clean cloth to prevent any scratches from occurring on the output window. Position the scanner so the red and green LEDs are pointed toward yourself.
2.Lay the stand on the scanner with the angled bracket pointing up and toward yourself.
3.Align the four clearance holes to the four holes in the scanner’s case. Fasten the scanner to the stand by inserting the four
4.Drill two holes into the work surface that correspond with the holes in the 216mm - 95mm (8.5" x 3.75") base of the stand.
5.Use two panhead or countersunk wood screws to attach the scanner and stand to the work surface. (Refer to Figure 1)
Figure 1
5
