Metrologic Instruments MS6520 manual Appendix B, Minimum Symbol Length Symbol Length Lock

APPENDIX B

Default Settings

Many functions of the scanner can be "programmed" - that is, enabled or disabled. The scanner is shipped from the factory programmed to a set of default conditions. The default parameter of the scanner has an asterisk (*) in the charts on the following pages. If an asterisk is not in the default column then the default setting is Off or Disabled. Every communication does not support every parameter. If the communication supports a parameter listed in the charts on the following pages, a check mark will appear.

Parameter	Default	RS-232*	Light Pen
UPC/EAN	*	a	a
Code 128	*	a	a
Code 93	*	a	a
Codabar		a	a
Interleaved 2 of 5 (ITF)	*	a	a
MOD 10 Check on ITF		a	a
Code 11		a	a
Code 39	*	a	a
Full ASCII Code 39		a	a
MOD 43 Check on Code 39		a	a
MSI-Plessey		a	a
MSI-Plessey, 10/10 Check Digit		a	a
MSI-Plessey, MOD 10 Check Digit	*	a	a
Paraf Support		a	a
ITF Symbol Lengths	Variable	a	a
Minimum Symbol Length	4	a	a
Symbol Length Lock	None	a	a
Bars High as Code 39	*		a
Spaces High as Code 39			a
Bars High as Scanned			a
Spaces High as Scanned			a
DTS/SIEMENS

27