Metrologic Instruments MX001 - page 33

29

C

LOSING THE

MX001

I

NDUSTRIAL

C

ONTROL

B

OX

1. Close the lid of the MX001 box.

2. Rotate the clamp clockwise while pushing down on the lid. Then move the

clamp to the right, positioning it over the ledge on the lid.

3. Fasten the clamp in place by tightening its screw with a flat blade

screwdriver.

C

ONNECTING THE

MX001

TO THE

S

CANNER

The supplied, scanner link cable is used to connect the MX001 box to a TECH

series scanner. This one meter cable carries the MX001’s control signals and is

terminated with an 8 and a 19 pin connector. (Other cable lengths are available,

contact Metrologic for details.)

1. Find the 8-pin male end of the scanner link cable and locate the wide

connector key found above pins A and G. Align this key with the

corresponding key on the MX001’s signal connector. Push in on the cable

connector slightly and rotate its ring clockwise until the connector locks in

place with a click.

2. Likewise, the 19-pin female connector found on the other end of this cable

is connected to the 19-pin male connector on the scanner case. This

connector is the one closest to the scanner window.

Contents

Main METROLOGIC INSTRUMENTS, INC. MX001 Industrial Control Interface Installation and Users Guide Page Page Page NTRODUCTION Page NTERNAL OMPONENTS ure 1 Fi LED 5 USA: 115V Operation 6 USA: 115V Operation (continued) USA: 230V Operation 7 Europe/Asia: 230V Operation 8 Europe/Asia: 115V Operation Page NPUT OWER AC l UTPUT OWER ONTROLLED l D TRIAC Page 14 Connecting the Sensor Temporarily Disabling the Sensor and/or Sensor Alarm 15 Sensors Powered Independently that Provide Either 12V, 5V or a 10mA DC Output Signal Page 17 Sensors that Provide Switch Closures or Relay Type Output 1 18 1 Low Voltage Self-Contained DC Sensors with a Current Sinking Output 19 1 Low Voltage Self-Contained DC sensors with a Current Sourcing Output 20 Universal Self-Contained Sensors that Provide a Single Pole/Double Throw (SPDT) Relay Output Page 22 23 24 Sensors that Provide Switch Closures or Relay Type Output with a Sensor Alarm 25 Low Voltage Self-Contained DC Sensors with Current Sinking Outputs and Sensor Alarm 26 Low Voltage Self-Contained DC Sensors with Current Sourcing Output and Sensor alarm 27 28 Page ONNECTORS IN 19-P IN AND Page 32 No Operation Green LED off: F2 Control Fuse Open: No Operation Sensor & TRIAC with Green LED on (other LEDs do not light): 33 No TRIAC Output with Red TRIAC LED On: F1 TRIAC Fuse Open: 34 TRIAC Output Active with Red TRIAC LED off: No Sensor Input Indication (Red S in LED does not light): 35 Reversed Sensor Input Indication (Red S in LED goes off when object is Erratic Sensor Operation: 36 Continuous Sensor Input Indication (Red S IN LED continuously on): Continuous Sensor Alarm Indication (Red A IN LED continuously on): Page 38 Operational Check Out Procedure for the MX001 Box: Page ARRANTY W IMITED OTICES N Class A Devices