3534
10. Stroboscopic mode
Fig. 18: Stroboscopic mode
In this mode several flash exposures are made on the same frame.This is
particularly interesting for motion studies and for special effects (Fig.18).
In stroboscopic mode, several flashes are fired at a certain flash frequency.
Consequently,this function is only possible with a partial light output level of 1/4
max.or less.
For a stroboscopic exposure it is possible to select a flash frequency of 1...30 Hz
in 1 Hz increments,and a number of flashes of 2...20 in single increments.
The maximum possible partial light output level in stroboscopic mode is auto-
matically adjusted (see Technical Data,Table 5).The partial light output level can
be adjusted manually to the minimal value of 1/256 to achieve short flash durations.
The LC display indicates the distance applicable to the adjusted parameters.The
displayed distance value can be adjusted to the actual shooting distance by vary-
ing the f-stop or the partial light output level.The aperture adjusted on the flash-
gun must be transferred to the camera.The distance range can be increased by
loading a high-speed film.
Ǻ
10. Stroboscopic mode
Fig. 19: Settings for stroboscopic mode
Setting procedure for stroboscopic mode:
Adjust the camera to manual mode,as explained in the manufacturer’s Operating
Instructions,and select the matching shutter speed (see Technical Data, Table 5).
1 Switch on the flashgun with the main switch .
• If the film speed has not yet been set on the mecablitz:
- Adjust the operating mode selector to A.
- Press the ISObutton and set the film speed with the „+“ or „-“ button
2Adjust the operating mode selector to .
• *Press the Zoom button and use the „+“ or „-“ button to set the zoom
value selected on the camera lens.
3Press the button N(double function of the ISObutton).
4Enter the desired number of flashes Nwith the „+“ or „-“ button .
5Press the f(HZ) button.
6Enter the desired flash frequencyf(Hz) with the „+“ or „-“ button .
• If necessary,press key Pand use the „+“ or „-“ button to reduce the
partial light output level.
1
25
3
4/6