Meyer Sound M3D-SUB

DECLARATION OF CONFORMITY ACCORDING TO ISO/IEC GUIDE 22 AND EN 45014

The manufacturer:

Meyer Sound Laboratories Inc.

2832 San Pablo Avenue

Berkeley, California 94702-2204, USA

Declares that the products: M3D™ and M3D-Sub conform to the

following product specications:

Safety: EN60065: 1998

IEC60065: 1998

EMC: EN55103-1: 1997 emission(1)

EN55103-2: 1997 immunity(2)

This device complies with the requirements of the Low Voltage

Directive 73 / 23 / EEC and the EMC Directive 89 /336 / EEC.

This device also complies with EN 55103-1 & -2. Operation is subject

to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation.

Environmental specications for Meyer Sound electronics products:

Operating Temperature: 0˚C to + 45˚C

Nonoperating Temperature: <-40˚C or > +75˚C

Humidity: to 95% at 35˚C

Operating Altitude: to 4600 m (15,000 ft)

Nonoperating Altitude: to 6300 m (25,000 ft)

Shock: 30g 11 msec half-sine on

each of 6 sides

Vibration: 10 Hz to 55 Hz (0.010 m

peak-to-peak excursion)

M3D and M3D-Sub QuickFly® Rigging Manual

The contents of this manual are furnished for informational purposes only, are subject to change without notice, and should not be construed as a

commitment by Meyer Sound Laboratories Inc. Meyer Sound assumes no responsibility or liability for any errors or inaccuracies that may appear

in this manual.

Except as permitted by applicable copyright law, no part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any

form or by any means, electronic, mechanical, recording or otherwise, without prior written permission from Meyer Sound.

M3D, TruPower, RMS, BroadbandQ, MAPP Online and REM are trademarks of Meyer Sound. Meyer Sound, SIM and QuickFly are registered

trademarks of Meyer Sound (Reg. U.S. Pat. & Tm. Off.). All third-party trademarks mentioned herein are the property of their respective trademark

holders.

Printed in the U.S.A.

Part Number: 05.105.400.01, Rev. B

Ofce of Quality Manager

Berkeley, California USA

July 19, 2002