Meyer Sound MM-4XP, MPS-488 - page 26

APPENDIX C: MM-4XP CABLE ASSEMBLY

26

4. Disassemble the EN3 5-pin female connector and feed one end of the cable through the boot, cable clamp housing, and

coupling ring.

5. If the EN3 end of the cable has not been stripped, strip the outer shielding 1” and then strip the black, red, blue, and

white wires .275”.

6. Solder the five exposed conductors to the five pins on the EN3 cord connector using the following wiring scheme.

7. Reassemble the EN3 5-pin female connector:

■Align the coupling ring’s side notches with the cord connector’s side notches and slide the couple ring onto the cord

connector.

■Carefully insert the end of the cable clamp housing into the cord connector until it locks into place. Snap the cable

clamps in the cable clamp housing into their compartments.

■Slide the boot forward so it covers the cable clamp housing completely.

Disassembled EN3 5-Pin Female Cable Mount Connector

Pin Destinations for EN3 5-Pin Female Cable Mount Connector

Cable clamp

housing

Boot Coupling ring

Cord connector

Pin #5, White,

audio (+)

Pin #4, Blue,

audio (–)

Pin #2, Red,

48 V DC (+)

Pin #1, Black,

48 V DC (–)

Pin #3, Unshielded,

audio shield

Pin #5, White,

audio (+)

Pin #4, Blue,

audio (–)

REAR

FRONT

Dimple identifies Pin #1

Contents

Main DECLARATION OF CONFORMITY ACCORDING TO ISO/IEC GUIDE 22 AND EN 45014 SYMBOLS USED IMPORTANT SAFETY INSTRUCTIONS ! SAFETY SUMMARY English Franais Deutsch Espaol CONTENTS Page CHAPTER 1: INTRODUCTION HOW TO USE THIS MANUAL THE MM-4XP MINIATURE LOUDSPEAKER Page CHAPTER 2: THE MPS-488 POWER SUPPLY THE MPS-488 FRONT PANEL AC Power Voltage and Load Current LEDs (18) Voltage LEDs (18) XX XXXXXX XXXX Common Routing Examples XXXX Input Impedance for Linked Channel Inputs Channel Outputs MPS-488P Channel Outputs MPS-488E Channel Outputs MPS-488 CURRENT DRAW SAFETY ISSUES Page CHAPTER 3: THE MM-4XP LOUDSPEAKER THE MM-4XP CONNECTOR Wiring the EN3-to-Pigtail Cables MM-4XP Current Draw and Cable Require- ments Cable Lengths and Cable Gauges for MM-4XPs THE MM-4XP LED Powering On (Green) Limiting (Yellow) Clipping (Red) CONNECTING MM-4XP LOUDSPEAKERS TO THE MPS-488 Page CHAPTER 4: MOUNTING THE MM-4XP IMPORTANT SAFETY CONSIDERATIONS MOUNTING THE MM-4XP WITH THE MUB-MM4XP U-BRACKET Page APPENDIX A: SPECIFICATIONS MM-4XP SPECIFICATIONS MPS-488 SPECIFICATIONS APPENDIX B: MM-4XP ACCESSORIES MM-4XP ACCESSORIES The following MM-4XP cable connectors and adapters are available from Meyer Sound. The following MM-4XP accessories are available from Meyer Sound. MM-4XP CABLE CONNECTORS AND ADAPTERS MM-4XP CABLES APPENDIX C: MM-4XP CABLE ASSEMBLY ASSEMBLING EN3-TO-PHOENIX LOUDSPEAKER CABLES Page ASSEMBLING EN3-TO-EN3 LOUDSPEAKER CABLES 4. Reassemble the EN3 5-pin male connector: connector. clamps in the cable clamp housing into their compartments. 5. Repeat the previous steps to attach the EN3 5-pin female connector to the other end of the cable.