UP-4XP OPERATING INSTRUCTIONS
29
6. Solder the five exposed conductors to the five pins on the EN3 cord connector using the following wiring scheme.
7. Reassemble the EN3 5-pin female connector:
■Align the coupling ring’s side notches with the cord connector’s side notches and slide the couple ring onto the cord
connector.
■Carefully insert the end of the cable clamp housing into the cord connector until it locks into place. Snap the cable
clamps in the cable clamp housing into their compartments.
■Slide the boot forward so it covers the cable clamp housing completely.
ASSEMBLING PHOENIX-TO-PHOENIX LOUDSPEAKER CABLES
When connecting UP-4XP loudspeakers equipped with Phoenix connectors to the MPS-488HPp power supply, you need a
Phoenix 5-pin female to Phoenix 5-pin female cable. The following procedure documents how to assemble this cable.
To assemble a Phoenix-to-Phoenix cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1 inch and then strip the
black, red, blue, and white wires by .275 inch.
Pin Destinations for EN3 5-Pin Female Cable Mount Connector
Assembled Phoenix-to-Phoenix Cable
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
Pin #2, Red,
48 V DC (+)
Pin #1, Black,
48 V DC (–)
Pin #3, Shield drain,
audio shield
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
REAR
FRONT
Dimple identifies Pin #1
1”
0.275”