13
CHAPTER 6
You can easily re-orient the UPJ-1P’s VariO rotatable horn
to its 80º or 50º conguration and back again. To rotate the
UPJ-1P’s horn, perform the following steps:
1. Remove the four (4) 10-32 x 5/8" grille cover screws
(two from the top and two from the bottom) from the
UPJ-1P.
2. Carefully remove the grille.
3. Remove the four (4) 10-32 x 1" horn ange screws.
4. Gently pull the VariO horn from the UPJ-1P cabinet, be-
ing careful not to over-stress its wiring.
5. Rotate the horn 90º clockwise to change it from its 80º
orientation to 50º. The wider ange around the horn’s
frame will now be along the sides of the frame instead
of the top and bottom (Figure 6.1).
Figure 6.1. The VariO horn at 80° x 50° for wide horizontal coverage (left)
and rotated to 50° x 80° for narrow horizontal coverage (right)
6. Place the horn back into the cabinet. It will t comfort-
ably snug.
7. Replace the four (4) 10-32 x 1" horn ange screws and
the four (4) 10-32 x 5/8" grille cover screws.
CHAPTER 6: ROTATING THE VARIO HORN80° 50°