MidiLand 8200 owner manual Connections, Features

			FEATURES
l 200 WATT RMS INTEGRATED POWER AMPLIFIER		l BUILT IN OVER HEAT PROTECTION
l 6½” WOODEN ENCLOSURE SUBWOOFER		l	BUILT IN FUSE
l	3” WOODEN ENCLOSURE SATELLITE	l	MAGNETIC SHIELDING
l	DTSâ READY	l	DYNAMIC SOUND QUALITY

lDOLBY DIGITALâ(AC-3) READY

lFULL FUNCTIONAL DOLBY DIGITALâ/ DTSâ

DECODER

CONNECTIONS

3With the power switch in the off position and the power transformer plug not connected, refer to the instructions and illustrations below:

lTurn off the computer or electrical sound source that you plan to connect the S4 8200 v2.0 to.

lCarefully remove the S4 8200 v2.0 components from their packaging.

lPlace the subwoofer on a flat, stable surface, preferably on the floor and apart from the wall, allowing a space at least 3 inches from the back and the sides of the unit.

lConnect the dual RCA to RCA cable from the back of the ADS 4000’s RCA connector to the corresponding RCA connector on the back of the subwoofer. Please refer to illustration 1-1.

lUsing the supplied speaker cable to connect the left, right, surround left, surround right and center satellite speaker to the subwoofer’s amplifer output. Make sure the postive and the negative speaker wires are plugged into the appropriate terminal. Please refer to illustration I-1.

lThe ADS 4000 may be connected to a sound source using three different types of input. Please refer to illustration I-2 to I-4. Also, check with your sound source manual for connection availability.

lPlug in the power cable to the ADS 4000 (power input) and to the 12V DC socket on the back of the subwoofer. For the subwoofer, plug in the power cable into the unit and the wall outlet.

lPress the Power button on the ADS 4000 (located on the front panel or the remote control) and the Subwoofer (located on the back panel of the subwoofer). Adjust the Subwoofer’s main volume with the volume control knobs located on the back panel. All other controls and function are selectable on the ADS 4000. Please refer to ADS 4000’s manual for deatails.)

a.Be sure not to tangle the power cord with the sound source cables, to prevent the sound signal from being interfered by the electrical current.

b.Be sure to turn the volume control counterclockwise before playing from audio source; increase the volume gradually after playing has started.

4