Back Panel | Antenna | PA |
| ||
| EXT | ||||
| Connector | Jack | |||
| Speaker | ||||
|
|
|
|
| |
|
|
|
|
| Jack |
|
|
|
|
| 13.8VDC |
|
|
|
|
| |
|
|
|
|
| Power |
|
|
|
|
| Cord |
Antenna Connector: Connect a standard
External Speaker Jack: When a speaker is connected to this jack, the internal speaker is
PA Jack: An optional PA speaker may be attached to your transceiver through the PA output jack on the back panel. This allows you to communicate with pedestrians or other vehicles through your CB microphone. The speaker connected to the “PA” jack should be rated at 8 ohms and 5 watts.
DC 13.8V Power Cord: Connects to power cord with in line 2 amp fuse.
Transceiver Operation
You should become familiar with the controls and complete the preceding installation instructions before attempting to operate your CB.
1.Rotate the on/off volume control clockwise to turn the unit on.
2.Adjust the squelch control fully
3.Adjust the volume for a normal listening level.
4.Rotate the squelch control just until the noise disappears.
5.Select the desired channel.
6.To transmit, press the PTT bar on the side of the microphone. Hold the microphone 2 to 3 inches from your mouth and speak in a normal voice.
7.To receive, simply release the PTT bar.
Warning: Do not attempt to make any internal adjustments. Internal adjustments and/or modifications can lead to illegal operation as defined by the FCC rules and regulations, Part 95. They must be made only by qualified technical personnel. Illegal operation can lead to serious consequences.
8 | midlandusa.com |
