WR-300/301 Owner’s Manual
Page 9 www.midlandradio.com
Choosing an
Choosing an Alert T
Alert Type (V
ype (Voice or Siren):
oice or Siren):
1. Press the “MENU” button to open menu options.
2. Press the “UP” arrow until Alert Mode is displayed on the screen. Press the “SELECT”
button and “VOICE” will start blinking.
3. If you want the voice alert, press the “SELECT” button.
4. If “VOICE” is chosen, the alert would sound for 8 seconds followed by 5
minutes of weather broadcast.
5. If you want the siren alert, press the “UP” arrow until “SIREN” is displayed,
then press the “SELECT” button to save your setting.
6. If “SIREN” is chosen, alert tones will sound for 5 minutes or until the “ALERT
ON/OFF” button is pressed.
T
To T
o Turn the
urn the Alert ON and OFF:
Alert ON and OFF:
To turn the alert on and off, press and hold the “ALERTON/OFF” button for 5 seconds until
you see “ALERT ON” blinking. While still holding down the button, press the “UP” arrow to
switch between “ALERT ON” and “ALERT OFF”. Press the “SELECT” button to save your
selection.
Setting the
Setting the Alert V
Alert Volume:
olume:
• To set the alert volume, press the “MENU” button.
• Press the “UP” arrow until “SIREN LEVEL” is displayed.
• Press the “SELECT” button and “LEVEL HIGH” or “LEVEL LO” will start blinking.
• Then press the “UP” arrow to choose “LEVEL HI” or “LEVEL LO” volume.
• Press the “SELECT” button to save your setting.
Select
Selectable
able Alert Option:
Alert Option:
You can program the WR-300/301 weather radio to only sound the voice or siren alert for cer-
tain weather emergency messages. Those messages unimportant to you can be programmed
to only display a message, minimizing annoyance.
To program the emergeny messages you want to silence, do the following:
• Press the “MENU” button until “DEFEAT SIREN” is displayed. Press the “SELECT”button.
• Using the “UP” arrow, scroll through the different alerts you may want to silence.
• When you have selected one, press the “RIGHT” arrow to change the status of the event
from “ALERT ENABLE” to “ALERT DISABLE”.
• Press the “MENU” button to save your selection and exit the programming option.
Reviewing S
Reviewing Stored S.A.M.E. Codes
tored S.A.M.E. Codes
To review your saved S.A.M.E. codes, do the following:
• Press the “MENU” button.
• Press the “UP” arrow until “COUNTY CODE” is displayed on the screen.
• Press “SELECT”
• Use the “UP” arrow to scroll through the S.A.M.E. memory code locations.
• All empty memory locations will appear as “------”.
• Press the “MENU” button when finished reviewing the S.A.M.E. codes.