Installation
Install the bracket on the rea_ ofthe
custom doo_ panel
[] Make sure the dishwasher is leve!,
[] Measure the distance X between the
round hole in the machine outer door
panel (shown in inset) and the lower
edge of the adioining cabinet door.
f
[] Place the door panel on aflat
surface, good side face down, being
careful notto scratch the surface,
Make certain that the bottom of the
panel istowards you,
[] Using a pencil, lightly draw avertical
centerline on the panel (See
illustration on the next page),
[] Draw a horizontal line X inches up
from the bottom edge of the panel,
For two piece panels:
Two piece panels should bemade so
that any ioining hardware is flush with
the back of the panel, Failure to do this
may impede proper operation ofthe
dishwasher,
In certain instances, you may be able
to use the mounting bracket supplied
with the machine to secure both pieces
to the dishwasher,
Consult your cabinet supplier /maker
for the best method of ioining the
panels,
_iWhen mounting the two pieces,
make sure that the desired finished
...............................................................................19