![](/images/new-backgrounds/1240934/24093415x1.webp)
3/8 in
Turn off welding power source/wire feeder.
Head Tube
CAUTION |
FLYING METAL CHIPS AND DIRT can cause injury and damage equipment. |
• Point gun away from people and in a safe direction when blowing out with compressed air. |
Remove nozzle, contact tip, and liner collet.
3/8 in
Remove liner.
Gun/Feeder
ConnectorBlow out gun casing.
Tools Needed:
3/8 in
To Reassemble Gun:
Install contact tip.
Insert new liner.
Install collet onto liner and tighten into gun/feeder connector using wrench.
Cut liner off near collet so that liner end is as close to drive rolls as pos- sible without touching.
Install nozzle.
Ref.