(Refer to RA 65 11 030)
(Refer to RA62 21 001) (Refer to RA51 16 198)

2

Procedure:

1. Disconnect negative battery terminal.

2. Remove the following components using information available in TIS:

• Drivers knee bolster (1)

• Center dash face (3)

• Radio side pillars (4)

• Radio (5)

• Glove box (6)

3. Remove the blue lock (1) from radio harness by releasing tab and sliding upwards, then remove following terminals (2) using AMP terminal removal tool p/n 61 1 134:

Pin #

Color

Description

9

White/Red

I-Bus

12

Brown

Ground

15

Red/Brown

KL 30

16

Violet/Blue

KL-R

Note: Wire colors may vary depending on vehicle production changes.

4. Cut original terminals off of 4 wires (1) removed from locations 9, 12, 15 &16. Cut wire as close as possible to existing terminal to maintain wire length.

5. Strip 1/8” of wire shielding from 4 wires.

6. Using terminal crimping tool (BMW p/n 408

449 or Snap-on PWC47) crimp new female bullet connectors included in kit onto each of the wires from previous step.

7. Insert pins (1) removed from radio connector into 4-pin connector (2) as follows:

Color

Location

Description

Violet/blue

1

KL-R

Red/brown

2

KL 30

White/red

3

I-Bus

Brown

4

Ground

Note: Wire colors may vary depending on vehicle production changes.

Installation Manual P/N 01 29 0 393 657