7
INSTALLATION PLACEMENT:
Select the location of the battery pack(s) with care and use the following
precautions;
1. Avoid locations near heating devices.
2. Avoid locations near water or excessive humidity.
3. Do not expose the Battery Pack to direct sunlight.
4. Route power cords where they cannot be walked on or damaged.
The battery packs and UPS unit must be placed on a level, smooth
surface and cannot be stacked more than 4 units high. All battery packs
that exceed 80 Lbs. must NOT be stacked more than 2 units high. The
UPS control unit must be installed on the side of the battery packs with
proper spacing between battery pack(s) and UPS, or on top of the battery
pack(s). DO NOT attempt to install battery packs on top of the control
unit.
BATTERY PACK CASTER REMOVAL:
Some Battery Pack cases are supplied with casters and provided with
replacement rubber feet. If mobility is not required, or if the Battery
Packs are to be stacked, the casters on the upper Battery Packs must be
removed and replaced by the rubber feet. Follow the instructions below
to install the rubber feet.
1. Move the Battery Pack into the area of its final location.
2. Remove the Battery Pack from the wooden skid.
3. Using appropriate support, raise the Battery Pack high enough to
gain access to the bolts securing the casters.
WARNING! Weight of the Battery Packs vary by model and are
extremely heavy. Use enough people, strong enough supports and
equipment to safely manipulate the Battery Packs.
4. Remove the four bolts securing the casters with the appropriate size
open-end wrench.
5. After removing each caster, screw the rubber feet into the holes
provided.