12
7. Reinstall the cover plates on the back of the UPS if they were
removed.
8. The unit is now ready for normal startup procedures as described in
the UPS owner's manual. Make sure all switches and breakers on all
units installed are placed in the ON position. Failure to have all of the
switches in the ON position may render the UPS inoperable or
reduce the runtime when multiple battery packs are installed.
For multiple battery pack installation, each battery pack is "daisy chained"
in a similar fashion, with the cable from the last battery pack connected to
the previous pack. Remove the protective strips only from the battery
connectors that you use.
STYLE 3: HARDWIRE AND PLUG & PLAY COMBINATION
CONFIGURATION INSTALLATION INSTRUCTIONS.
1. Make sure the installation placement and caster removal procedures
mentioned above have been carefully followed.
2. Be sure the UPS Power switch is in the OFF position. If this model of
battery pack contains a circuit breaker, make sure the battery pack
circuit breaker is in the OFF position.
3. Locate the terminal block or plug & play connection on the back of
both the UPS and Battery Pack for installation of the Battery Pack
connection wires. To locate and properly identify the connection
points, refer to the Installation section of the UPS owner's manual.
To locate the terminal block on the Battery Pack, you may need to
remove the top cover of the Battery Pack.
Note: On some models, the terminal block may be accessed from the
rear panel of the battery pack.
4. When connecting this configuration, you may have Plug and Play
connections on either the UPS or the battery pack. This will be
determined by which model you have. The drawing below will reflect
a Plug and Play connection on the battery pack and a hardwire
connection on the UPS. Your application may be reversed.