Mirage Loudspeakers PS-8 owner manual Using High Level Connections see Diagram

o w n e r s m a n u a l P S - 8 / P S - 1 0 / B P S - 1 0 0 i

Using High Level Connections (see Diagram 1)

On the rear of your Mirage subwoofer cabinet is a block designated “High Level”. This block contains two pairs of speaker terminals. These should be connected to speaker output terminals of your amp./receiver. Each pair of terminals are color coded black/red.

NOTE: These terminals will accept up to 18 Gauge speaker wire.

REMEMBER: Always connect red-to-red and black-to-black, when making the connections between amp/receiver to subwoofer. If you inadvertently reverse one of the connections (ie. red-to-black), you will notice a lack of bass from your subwoofer.

Using the “Subwoofer Output” of an A/V Receiver or Processor (See Diag. 2 Low Level Connection1)

This method uses a single RCA-to-RCA interconnect cable to connect the

“SUBWOOFER OUTPUT” jack from your A/V receiver or processor to the subwoofer “INPUT”. This method does not remove low frequencies from your main speakers, and they will continue to reproduce bass frequencies.

Using External Crossover (See Diag. 3 Low Level Connection 2)

This method uses a single RCA-to-RCA interconnect cable to connect the

“SUBWOOFER OUTPUT” jack from an external crossover to the “XOVER INPUT” of your subwoofer. This method by-passes the subwoofer’s built-in low pass crossover and level control, thus, all subwoofer functions are controlled by the external crossover. (See External Crossover Owner’s Manual for more details)

7