How To Use Your Juice Factory
The Juice Factory is made for the express purpose of extracting flavourful vitamin and mineral filled juices of raw fruits and vegetables by means of centrifugal force.
Operation
Before first using your Juice Factory, carefully wash and dry all parts that will come into contact with food.
Prepare material to be processed by washing thoroughly and peeling as required. Remove all pits, stones and large seeds.
Cut large fruits or vegetables into small pieces when using Inlet Chute.
Plug cordset into a regular 240V earthed outlet.
Push power button ‘ON’. To adjust speed push ‘I’ for a slow setting and ‘II’ for a faster setting.
Juice Extractor
Check to be sure that the Juice Cup is in place and feed material to be processed into the Inlet Chute at a moderate and steady rate. Use the Pusher as required to clear the Chute. Avoid excessive force when using the Pusher. A moderate, steady pressure is all that should be required. Too much pressure may cause the material to jam the Inlet Chute, or cause distortion of the Cutter/Strainer Assembly.
Note: If the Chute does become jammed from excessive force, proceed as outlined under (B) following, clearing the chute before reassembling the parts.
Note: Never use fingers or any other object other than the Pusher to clear the Inlet Chute. If the food cannot be dislodged, turn the motor off. Unplug power cord from outlet before proceeding.
Remove the Cover from the Juice Extractor assembly, and use a rubber spatula or long handled wooden spoon to clear the Inlet Chute. Continue processing until one or more of the following conditions occur:
(A)If the Juice Cup is full before all the material is processed, push the power button ‘OFF’ and allow the Juice Cup to remain in place until the Motor stops and juice stops flowing. Transfer the juice to a separate container. Replace the Juice Cup or push the power button ‘ON’ to continue processing.
(B)If the Pulp Collector is full before all the material is processed, push the power button ‘OFF’, and allow the Juice Cup to remain in place until the Motor stops and juice stops flowing.
Unplug power cord from outlet before proceeding.
Remove the Juice Factory Assembly and dismantle parts as outlined under ‘Disassembly Instructions’.
Remove pulp from the Pulp Collector. Reassemble parts as outlined under ‘Assembly Instructions’.
5
