Mitsubishi Electronics Diamond Pro 750SB, Diamond Plus 93SB, 93 SB, 750 SB user manual Quick Start

Quick Start

To attach the Diamond Pro 750SB / Diamond Plus 93SB monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.If necessary, install the display card into your system. For more information, refer to the display card manual.

3.For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the Diamond Pro 750SB / Diamond Plus 93SB Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the captive signal cable to the Diamond Pro 750SB / Diamond Plus 93SB Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

4.Connect one end of the power cord to the Diamond Pro 750SB / Diamond Plus 93SB monitor and the other end to the power outlet (Figure C.1).

5.Turn on the monitor (Figure D.1) and the computer.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

Figure A.1 Figure B.1

15-pin mini D-SUB

Mac Adapter

(Not Included)

Captive Signal Cable Captive Signal Cable

Diamond Pro 750SB / Diamond Plus 93SB 5