2 - 1
2. INSTALLATION
2. INSTALLATION
CAUTION
Stacking in excess of the limited nu mber of products is not allowed.
Install the equipment on incombustibl e material. Installing them directly or close to
combustibles will lead to a fire.
Install the equipment in a load-bearing place in accord ance with this Instruction
Manual.
Do not get on or put heavy load on the equipment to prevent injury.
Use the equipment within the specified environmental condition range. (For the
environmental conditions, refer to s ection 2.1.)
Provide an adequate protection to prevent screws, m etallic detritus and other
conductive matter or oil and other com bustible matter from entering the servo
amplifier.
Do not block the intake/exhaust ports of the servo amplifier. Otherwise, a fault ma y
occur.
Do not subject the servo amplifier to dr op impact or shock loads as they are
precision equipment.
Do not install or operate a faulty servo amplifier.
When the product has been stored for an extended period of time, consult
Mitsubishi.
When treating the servo amplifier, b e careful about the edged parts such as the
corners of the servo amplifier.
2.1 Environmental conditions
Environment Conditions
[] 0 to 55 (non-freezing) In
operation [] 32 to 131 (non-freezing)
[] 20 to 65 (non-freezing)
Ambient
temperature In storage [] 4 to 149 (non-freezing)
In operation
Ambient
humidity In storage 90%RH or less (non-condensing)
Ambience Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Altitude Max. 1000m (3280 ft) above sea level
[m/s2]
5.9 [m/s2] or less
Vibration [ft/s2]
19.4 [ft/s2] or less