12-71
1
2
3
12
6
6
7
8
12.1 Error Code List
12.1.8 Error code list (6000 to 6999)
6061
[CPU MODE DIFF.]
In a redundant system, the operation mode
(backup/separate) differs between the control
system and standby system.
(This can be detected from the standby system of
the redundant system.)
■Collateral information
•Common Information:–
•Individual Information:–
■Diagnostic Timing
•When an END instruction executed
Match the operation modes of the control system
and standby system.
RUN:
Off
ERR.:
Flicker
CPU Status:
Stop
QnPRH
6062
[CPU MODE DIFF.]
Both System A and B are in the same system
status (control system).
(This can be detected from the system B of the
redundant system.)
■Collateral information
•Common Information:–
•Individual Information:–
■Diagnostic Timing
•At power ON/At reset/At tracking cable
connection
Power the CPU module (System B) which resulted
in a stop error, OFF and then ON.
6100
[TRK. TRANS. ERR.]
•An error (e.g. retry limit exceeded) occurred in
tracking data transmission.
(This error may be caused by tracking cable
removal or other system power-off (including
reset).)
•The error occurred at a startup since the
redundant system startup procedure was not
followed.
■Collateral information
•Co mmon Information:Tracking transmission data
classification
•Individual Information:–
■Diagnostic Timing
•Always
•Check the CPU module or tracking cable. If the
error still occurs, this indicates the CPU module
or tracking cable is faulty. (Contact your local
Mitsubishi representative, explaining a detailed
description of the problem.)
•Confirm the redundant system startup procedure,
and execute a startup again.
RUN:
On
ERR.:
On
CPU Status:
Continue
6101
[TRK. TRANS. ERR.]
•A timeout error occurred in tracking (data
transmission).
(This error may be caused by tracking cable
removal or other system power-off (including
reset).)
•The error occurred at a startup since the
redundant system startup procedure was not
followed.
(This can be detected from the control system or
standby system of the redundant system.)
■Collateral information
•Co mmon Information:Tracking transmission data
classification
•Individual Information:–
■Diagnostic Timing
•Always
Error
Code
(SD0)
Error Contents and Cause Corrective Action LED Status
CPU Status
Corresponding
CPU