Appendices 111
Remove the Shield
1. Using a Phillips screwdriver, remove the screws that
secure the top plate and lift off the plate. Keep the
plate and screws for reuse. See figure 1.
Figure 1. Remove the
screws securing the
top plate and lift off
the plate.
Top Plate
2. Note the location of the six clips that hold the
Diamond Shield in place. Slide the card along the
channel until it meets each clip. See figures 2 and 3.
See figure 3 detail
Figure 2. Six clips hold the Diamond Shield on the T V.
Diamond Shield
Slide card in channel
to locate clips. The
clips are visible at the
edge of the Diamond
Shield.
Figure 3. Locating the clips
The Diamond Shield ™ is an optional protective cover for the front of the TV s creen. Models WD-62927 and WD-73927
come from the factory with the Diamond Shield installe d. For Models WD-62827 and 73827, the Diamond Shield may
be purchased separately.
These instructions explain removal and installation of the Dia mond Shield™ and the decorative trim that covers gaps
around the TV screen when the shield not installe d.
You need the following for this procedure:
Trim kit (included with the TV)
Phillips screwdriver
Small plastic card or plastic putty knife. An expire d credit card or similar expendable card works well.
Soft cotton gloves
Note: Use care to avoid scratching the TV screen or Diamond S hield.
This procedure is best performed by two peop le.
Appendix H: Diamond Shield Removal and Installation