Mitsubishi Electronics X50, X70 user manual Basic connections, Projector + AV equipment

Basic connections

This projector can be connected to equipment such as PC, VCRs, video cameras and DVD players.

Important:

•Make sure that your equipment is turned off before connection.

•Plug in firmly and unplug by holding the plug, not by pulling the AC power cord.

•If connected units are set too close to one another, the image may be affected.

•Refer to the user manual of each component for details of connections.

Projector + AV equipment

Important:

•Match the color of video and audio plugs on the AV cable with the connections.

•S-video signals take priority over video signals. If you input both S-video signals and normal video signals at the same time, the normal video input automatically is inhibited.

Connect either one of these.

Ferrite core

to S-video

output

to video

output

	to audio
VCR etc.	output

to S-video

input

to video

input

to audio

input

•Speaker output is mono.

•Select AUDIO MODE 2 to hear and to sound for the VIDEO. (Refer to page 16).

•When connecting audio output of equipment which audio output is mono, connect to audio input L terminal.

Projector + DVD player or HDTV decoder

Some DVD players have output terminal for 3 line fitting (Y, CB, CR). When connecting them to the projector, connect to COMPUTER IN of the projector. In this case, set “ Y, CB, CR” for COMPUTER INPUT setting in SIGNAL menu.

DVD player generally has SDTV system component video output (Y, CB, CR) terminals. HDTV decoder has HDTV system component video output (Y, PB, PR) ter- minals. When connecting the projector with DVD player or HDTV decoder, the signal cuircuit automaticaly applied to either of them. In this case, the COMPUTER INPUT in the SIGNAL menu becomes [Y, CB, CR/Y, PB, PR].

DVD player or HDTV decoder

		BNC-RCA connector
		(optional)
Y CB(PB) CR(PR)	No connection
G B R	HD/CS	VD	to COMPUTER
			IN

Mini D-SUB 15 pin-BNC conversion cable (optional)

•Y, PB, PR is an example of the terminal names for a HDTV decoder.

•The terminal name is different depending on the connected equipment.

•Use mini D-SUB 15 pin-BNC conversion cable for connection.

•Some DVD players may not project the image correctly.

•When connecting with HDTV equipment which has R, G, B output, set RGB for the COMPUTER INPUT in the SIGNAL setting menu.

•Change the setting in the SIGNAL menu, when 525p signal is inputted. (Refer to page 20).

EN – 10